critical voltage
英 [ˈkrɪtɪkl ˈvəʊltɪdʒ]
美 [ˈkrɪtɪkl ˈvoʊltɪdʒ]
网络 临界电压
双语例句
- The work of this paper can be used to predict the critical voltage of dielectric EAP actuator when the failure occurs and guarantee the safety working of dielectric EAP actuator.
本文的研究可用于预测介电型EAP驱动器发生失效的临界电压，有利于保障驱动器的安全工作。 - The calculation example shows that this method effectively avoids the power flow convergence when close to the critical voltage collapse point.
算例表明所提算法有效规避了在接近崩溃点附近潮流收敛困难的问题。 - Voltage stability Critical voltage Critical maximum power Weakest bus;
电压稳定；临界电压；临界功率；弱节点； - The calculation results can be taken as the judging basis for the abundance of motor critical instability and critical voltage instability in power system.
所获结果可作为判断电力系统中异步电动机临界失步和临界电压失稳裕度的依据。 - Based on the differences of critical voltage value, the identification method on species of fruits is proposed. The test result shows that the identification rates for apple, kiwifruit and pear are 100%, 93% and 90%, respectively.
文中提出了基于电压临界值的果品种类识别方法，验证结果表明，该方法对苹果、猕猴桃和梨的识别率分别为100%，93%和90%。 - When the voltage of signal is less than critical voltage value, each electric parameter keeps constant, while capacitance and resistance decrease and loss tangent increases sharply with increase of voltage when the voltage is bigger than the critical voltage value.
当信号电压小于电压临界值时，果品的各项电参数值基本保持不变，但当信号电压大于该临界值时，随着电压的增大，果品的电容和电阻值减小，损耗角正切急剧增大。 - A high-accuracy band-gap voltage reference circuit using trimming meets the critical voltage requirement of Li-Ion batteries.
设计带修调的高精度带隙电压基准，满足锂离子电池对充电电压的严格要求； - It also proposes the possibility of static excitation being applied to the sensor and the analysis methods in the bending of the movable system under the electrostatic forces and critical voltage are presented.
提出了将静电激振法用于该传感器的可能性，并给出了在静电力作用下可动系统（悬臂梁）弯曲的分析方法及临界电压的确定方法。 - Moreover, this paper presents an analysis for the conditions of the critical voltage stability and synchronism stability limit in the bulk power systems.
此外，本文还对复杂电力系统中临界电压稳定与同步稳定极限的条件进行了探讨。 - The stability of uniform gap and nonuniform gap capacitive transducer is analyzed in the paper. Two sorts of critical polarization voltage and critical displacement of mobile system and also the actual transducer are calculated.
对均匀间隙和不匀均间隙式电容传感器的稳定性进行了分析，给出这两种临界极化电压及可动系统临界位移的计算方法，并针对实际传感器进行了计算。 - The influences of the geometrical size of plate, functionally gradient index and displacement at mid-plane of plate on the critical voltage are discussed.
在此基础上，讨论了板的几何尺寸、材料梯度指数的变化和中面变形等因素对临界电压（电载荷）的影响。 - Based on analyzing of the purpose of the static voltage stability limitation of critical voltage and critical power, the voltage and current characteristics of simple alternative circuit are discussed, and the way of confirming var compensation node of electric power system is indicated.
基于对临界电压和临界功率在静态电压稳定极限作用的分析，本文讨论简单交流电路的电压电流特性，提出了确定电力系统无功补偿点的方法。 - This paper analyzes the relationship between the critical voltage stability and synchronism stability limit in power system.
本文旨在分析电力系统临界电压稳定与同步稳定极限的内在关系。 - Characteristic analysis for critical voltage collapse based on alternating current circuit
基于交流电路的临界电压崩溃特性分析 - The critical voltage value is different in different fruits. Under 10 kHz, the value is 0.8,1.8 and 1.4 V for apple, kiwi fruit and pear respectively.
不同果品的电压临界值不同，10kHz信号频率下，苹果、猕猴桃和梨的电压临界值分别为0.8,1.8和1.4V。 - The electric parameters of kiwifruit and pear also have the same frequency characteristic as apple and different critical voltage values, which are 1 V, 1.8 V and 1.4 V, respectively for apple, kiwifruit and pear under 10 kHz.
猕猴桃、梨同苹果电参数的频率特性相同，而且也存在电压临界值；10kHz下，苹果、猕猴桃和梨的电压临界值分别为0.8、1.8和1.4V。 - By the study of the influence on the voltage to the transformers'power losses, this paper presents the conception of critical voltage spread load rate, which is used to decide the direction of the voltage spread.
通过研究电压对变压器功率损耗的影响，提出了临界电压调整负载率的概念，用于决定配电变压器运行时电压调整的方向。 - To the problem of voltage collapse in power system, the load critical voltage collapse power flow ( CVCPF) algorithm in power system with power mode load is discussed under the load critical voltage collapse power flow analysis in this paper.
针对电力系统电压崩溃问题，该文在负荷临界电压崩溃特性分析基础上，讨论功率型负荷的电力系统临界电压崩溃的潮流计算方法。 - The critical driving voltage, static friction force and normal force are all calculated theoretically.
对结构的临界驱动电压、静态摩擦力及正压力进行了理论推导。 - This paper, based on the equivalent theory, proposed the equivalent electrical distance method for determining the voltage stability bus and the critical voltage and critical power.
电力系统电压静态稳定问题主要解决弱节点的确定和临界状态及其稳定裕度的求取。 - Concerning the Voltage quality of the dielectric peculiarity parameters of gooseberries, we lead in a "critical voltage value", if the test voltage is more than the" critical voltage", the capacitance and resistance decrease fast, while the loss tangent increase rapidly.
猕猴桃介电参数的电压特性有一电压临界值，当信号电压大于临界值时，电容和电阻迅速减小，损耗角正切急剧增大。 - In this paper, firstly, the characteristics of critical point are expressed with ABCD parameters for constant power load in π type circuit, these characteristics include critical voltage ( amplitude and angle), critical load impedance and critical power, etc.
文中针对π型电路求出了用A、B、C、D参数表示的恒功率负荷的临界点特性，如负荷临界电压（幅值和相角），负荷临界阻抗和临界功率； - Analysis of Voltage Stability Margin Index and Study of Voltage Stability Region for Critical Voltage Collapse in Power System
电力系统临界电压崩溃的距离裕度指标分析及电压稳定域的研究 - Determination of Super-Capacitor Critical Voltage in Voltage Dip Compensate System
电压暂降补偿系统中超级电容临界电压的确定 - Results show that the deflection increases continuously until the critical voltage is reached, the beam end deflection is 0 42~ 0 44 the initial gap distance.
结果表明，电压增高，梁的挠度随之增大，达到临界电压时，梁末端的挠度与变形前的间隙之比为042~044。 - By using a flexible node algorithm for equality constrains condition in power system and adjusting load for local node, we obtain the critical voltage collapse node.
采用电力系统等约束柔性节点算法和局部节点调节负荷的试探法获取了算例的临界电压崩溃点，在此基础上，通过算例验证该方法，验证结果表明所提出的方法可行有效。 - When the supplied voltage reached the certain critical voltage, the contact angle saturation phenomenon will be appear. The contact angle would not change when the supplied voltage was increased.
当外加电压达到临界电压时，会出现接触角饱和现象，然后随电压升高接触角无明显变化。 - PEDOT: PSS ( P VP4083) improved the holes gathering capabilities and the critical breakdown voltage of the device as a modified material for the anode.
同时研究了以PEDOT：PSS（PVP4083）作为阳极修饰材料对于电极的空穴收集能力以及器件的临界击穿电压的影响。 - Program is programmed to calculate critical length of arc on top and button, critical leakage current and critical flashover voltage.
并编程求解了三个平板模型的临界电弧长度、临界泄漏电流和临界闪络电压。